hardware-modules

The PoC Library has been forked to github.com/VHDL/PoC. See new address below

Valve Index DEV Frunk 1.0 Custom made to give the Index more Mounting Options for Adapters and DIY Devices. All Modifications that i create are Reversible and will not damage the Product. (Except you try to break it on purpose)

QN8035 based Raspberry Pi FM radio receiver

Computer Architecture -VLSI -Verilog Codes-Xilinx-Irsim

Yet Another LCD Interface

Hardware/Software | Generic ISP Interface, MCU PIC8-bit SPI Interface. 2.4GHz, Low Energy Bluetooth.

Hardware/Software | NANDFlash Memory Interface to SPI capable device.

Hardware/Software | GPIO Out is Uni/Bi Coil Compatible, MCU/ADC/TTL, VSense over Darlington Transistor Array

A sealed, swappable phase-change thermal cartridge in a few standard temperature ranges (cold chain, comfort and hot holding) that stores heat or cold and drops into coolers, cabinets and heat exchangers.

An open battery management board for small LiFePO4 packs (4 to 16 cells) with cell balancing, protection and a documented state-of-charge estimate, reusable across the lab's vehicles, storage and field kits.

A standard controller and safety module (open motor controller, e-stop, speed limit and brake interlock) with a named reference hub motor, which the lab's mobility and automation designs bolt on rather than re-engineer.

A solar-powered, weatherproof sensor node with a common mounting, power and radio core, so any lab project that needs to measure something outdoors starts from the same tested base instead of a new enclosure and charger each time.